EM2GO Pro Power G2 Bedienungsanleitung Seite 45

Fig. 5-1 Minimum space requirements for wall mounting
Proceed as follows to install the charging station on the wall.
1. Remove the metal bracket from the charging station by loosening the two screws on the
underside of the charging station and removing the metal mounting plate from the charging
station.
2. Drill 4 holes with a diameter of 8 mm and a depth of at least 50 mm at a distance of 70 mm in
width and 280 mm in height. Use the upper and lower holes of the metal bracket as shown in Fig.
5-2.
3. Insert the 8x40 expansion anchors into the wall.
4. Screw the two upper M5x45 hexagon cross-head screws halfway into the wall and attach the
metal bracket.
5. Screw in the other screws and tighten all screws to secure the metal bracket.
GB
45