Control - Menus - Nibe Rmu 40 Installateurhandbuch

Control – Menus
MAIN MENU
Product
name
climate system 1
temperature
temporary lux
ventilation
op. mode
service settings
SUB-MENUS
Status information for the relevant menu can be found on
the display to the right of the sub-menus.
temperature Setting the temperature for the climate sys-
tem. The status information shows the set value for the cli-
mate system.
temporary lux Activation of temporary increase in the hot
water temperature. Status information displays "off" or what
length of time of the temporary temperature increase re-
mains.
ventilation Setting the fan speed. The status information
shows the selected setting. This menu is only displayed for
the exhaust air heat pumps and ground source heat pumps
with the exhaust air module accessory.
op. mode Activation of manual or automatic operating
mode. The status information shows the selected operating
mode.
service settings Setting which climate system is to be
controlled by the room unit. Hold the back button in for 7
seconds to access the Service menu.
RMU 40 | EN
MENU 1 - TEMPERATURE
If the house has several climate systems, this is indicated
on the display by a thermometer for each system.
SETTING THE TEMPERATURE (WITHOUT ROOM
SENSORS ACTIVATED):
Setting range: -10 to +10
The display shows the set values for heating (curve offset).
To raise or lower the indoor temperature, increase or reduce
the value on the display.
Use the arrow buttons to set a new value. Confirm the new
setting by pressing the OK button.
The number of steps the value has to be changed to achieve
a degree change of the indoor temperature depends on the
heating unit. One step for underfloor heating whilst radiators
may require three.
Setting the desired value. The new value is shown on the
right-hand side of the symbol in the display.
SET THE TEMPERATURE (WITH ROOM SENSOR
INSTALLED AND ACTIVATED):
Setting range: 5 – 30 °C
The value in the display appears as a temperature in °C if
the heating system is controlled by a room sensor.
To change the room temperature, use the arrow buttons to
set the desired temperature in the display. Confirm the new
setting by pressing the OK button. The new temperature is
shown on the right-hand side of the symbol in the display.
NOTE!
An increase in the room temperature can be
slowed by the thermostats for the radiators or
under floor heating. Therefore, open the thermo-
stat valves fully, except in those rooms where a
cooler temperature is required, e.g. bedrooms.
temperature 1
19