Nibe RMU 40 Installateurhandbuch Seite 20

TIP!
Wait 24 hours before making a new setting, so that
the room temperature has time to stabilise.
MENU 2 - TEMPORARY LUX
off
3 hrs
6 hrs
12 hrs
Setting range: 3, 6 and 12 hours, as well as mode "off"
When hot water requirement has temporarily increased this
menu can be used to select an increase in the hot water
temperature to lux mode for a selectable time.
NOTE!
If comfort mode "luxury" is selected in the main
product's menu 2.2, no further increase can be
made.
The function is activated immediately when a time period
is selected and confirmed using the OK button. The time to
the right displays the remaining time at the selected setting.
When the time has run out the menu returns to "from" mode.
Select "off" to switch off
20
temporary lux 2
temporary lux .
MENU 3 - VENTILATION
normal
speed 1
speed 2
speed 3
speed 4
Setting range: normal and speed 1–4
NOTE!
This menu is only displayed for the exhaust air
heat pumps and ground source heat pumps with
the exhaust air module accessory (FLM).
The ventilation in the accommodation can be temporarily
increased or reduced here.
When you have selected a new speed a clock starts a count
down. When the time has counted down the ventilation
speed returns to the normal setting.
If necessary, the various return times can be changed in the
heat pump menu 1.9.6.
MENU 4 - OP. MODE
auto
addition
manual
heating
add. heat only
OP. MODE
Setting range: auto, manual, add. heat only
FUNCTIONS
Setting range: addition, heating, cooling
The main product's operating mode is usually set to "auto".
It is also possible to set the main product to "add. heat only",
when only additional heat is used, or "manual" and then se-
lect the functions that will be permitted.
Change the operating mode by marking the desired mode
and pressing the OK button. To select selectable functions
that are permitted or not, mark the function using the arrow
buttons and press the OK button.
ventilation 3
op. mode 4
cooling
RMU 40 | EN