Herunterladen Inhalt Inhalt Diese Seite drucken

Einbau Mit Seatfix; Installing With The Seatfix - RECARO Monza Nova IS Montage- Und Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für Monza Nova IS:
Inhaltsverzeichnis

Werbung

13
14
15

3.2 Einbau mit Seatfix

Achtung!
Zur Sicherung Ihres Kindes immer den fahrzeugeigenen
Dreipunktgurt verwenden! Das Seatfix System verbessert den
Schutz beim Seitenaufprall und sichert den Sitz bei Nichtgebrauch.
Stecken Sie die Einführhilfen durch den Polsterschlitz von Rücken-
lehne und Sitzfläche auf die Isofixbügel. Dies ist nicht erforderlich
bei bereits fest installierten Einführhilfen. Achten Sie darauf, dass
die offene Seitenfläche nach oben zeigt.

3.2 Installing with the Seatfix

Attention!
Always use the vehicle's 3-point seat belt to secure your child! The
Seatfix system improves the level of protection in the event of a
side impact, and secures the seat when it is not in use. Insert the
insertion aids through the upholstery slit in the back rest and seat
and attach to the Isofix attachment brackets. This is not necessary
where insertion aids are already permanently installed. Ensure that
the open side is facing upwards.
A
Zum Einbau in Ihr Fahrzeug müssen die Seatfix- Konnektoren
(A) ausgefahren werden. Dazu drücken Sie die Rasthebel an den
Seiten des Sitzteils und ziehen die Seatfix-Konnektoren nach
hinten bis zum Anschlag heraus.
To install the child car seat in the car extend the Seatfix connectors
(A). Press the locking levers at the sides of the seat and pull back
the Seatfix connectors until the limit stop is reached.
Rasten Sie die Seatfix-Konnektoren (A) in die Isofix- Bügel ein,
dabei muss die grüne Markierung an beiden Konnektoren sichtbar
werden. Prüfen Sie das sichere Einrasten durch beidseitiges
Ziehen an der Sitzfläche. Schieben Sie den Kindersitz nun mit
gedrückten Rasthebeln in Richtung Fahrzeugsitz, bis er mit der
Rückenlehne an der Rückenlehne des Fahrzeugsitzes flächig
anliegt.
Lock the Seatfix connectors (A) onto the Isofix attachment bracket,
making sure the green mark on both connectors is visible. Check
that they are firmly locked by pulling both sides of the seat. Then
A
push the child car seat, with the locking levers pressed down,
towards the vehicle seat until the back rest is positioned up against
the back rest of the vehicle seat.
DE
GB
LT
LV
RU
CZ
KO
JP
FR
NL
7839-6-00
IT
HR
HU
SK
CN
TW
S
E
U
M

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis