Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch PLL 5 Originalbetriebsanleitung

OBJ_BUCH-311-010.book Page 22 Tuesday, January 10, 2017 2:55 PM
22 | English
Checking Horizontal/Vertical Lines with the Spirit Levels
(see figure F)
The measuring tool can be used as a contractors level for checking hori-
zontal or vertical lines, e.g., for the level set-up of a washer or a refrigera-
tor. Position the measuring tool with the aluminium supporting surface 7
facing against the surface to be checked. When positioning against hori-
zontal surfaces, the aluminium supporting surface 7 must face down-
ward. When positioning against vertical surfaces, the exit opening for the
laser beam 8 must face upward.

Working Advice

Mounting to a Wall
There are three methods for mounting the wall holder on various surfaces:
– Fastening with Pins (see figure G): With the pins 2 provided, the wall
holder can be fastened to drywall or wooden walls. Insert the pins
through the openings in the wall holder as shown in the figure.
– Fastening with a Screw: Place the wall holder 1 via the opening on the
back side onto a screw that projects lightly out of the wall.
– Fastening with Adhesive Tape (see figure H): The wall holder can al-
so be fastened with commercially available adhesive tape (not includ-
ed in the delivery scope) as shown in the figure.
In all three mounting methods, ensure that the wall holder 1 is securely at-
tached to the surface. The wall holder slipping out of position can lead to
incorrect measurements.
Attach the measuring tool via the magnets 13 onto the metal plate 3 of the
wall holder 1.
Belt Clip
With the belt clip 4, the measuring tool, as an example, can be hooked to
a belt and is always at hand.

Maintenance and Service

Maintenance and Cleaning

 Check the measuring tool each time before use. In case of visible
damage or loose components inside the measuring tool, safe function
can no longer be ensured.
1 609 92A 1Y7 | (10.1.17) Bosch Power Tools