Main Unit; Pre-Filter; Sensors - Sharp FU-S63E Bedienungsanleitung

MAIN UNIT

Care Cycle 1 month
To prevent dirt or stains on the main unit, clean as often as necessary. If stains are allowed to
remain, they may become hard to clean.
Wipe with a dry, soft cloth
For stubborn stains or dirt, use a soft cloth dampened with warm water.
Do not use volatile fluids
Benzene, paint thinner, polishing powder, etc., may damage the surface.
Do not use detergents
Detergent ingredients may damage the unit.
Keep the unit away from water

PRE-FILTER

Care Cycle 2 months
As shown in a figure, clean the top surface of the
Pre- Filter lightly with a vacuum cleaner.
When Pre-Filter is very dirty, wash it in water with
mild kitchen detergent and dry Pre-Filter well in
the shade.

SENSORS

Care Cycle 2 months
Remove dust from the surface of the hole of the sensors using a vacuum cleaner.
SENSOR FILTER CARE
Detach the sensor filter and tap it lightly with your hand to remove the dust.
If it is very dirty, wash it with water and then allow it to dry thoroughly.
(DUST SENSOR, ODOUR SENSOR, TEMPERATURE/HUMIDITY SENSOR)
(The sensor Filter is in the sensor cover.)
Hole of Temperature/Humidity Sensor
Sensor Cover
Sensor Filter
It does not have a front
and a back.
E-17
Pre-Filter
Hole of Odour Sensor
Hole of Dust Sensor
(When the sensor cover is removed,
it will be seen.)