Inserting Batteries In The Remote Control; Battery Information; Remote Control Use - Sharp FU-S63E Bedienungsanleitung

INSERTING BATTERIES IN THE REMOTE CONTROL

• The battery life is about 1 year.
• The batteries for this remote control are for initial use only . Change the batteries
when necessary.
• Incorrect usage of the batteries may cause battery fluid leakage and/or damage.
Take care of the following when handling:
• When replacing the batteries, replace both batteries with new ones of the same
type. (Use 2 AAA manganese batteries.)
• When not using the unit or remote control for an extended period, remove the bat-
teries.

REMOTE CONTROL USE

Operate with the remote control facing the
•
main unit receiver.
• The signal range is about 7m.
• Make sure there are no objects blocking
the path of the signal.
• A beep sound will be heard from the main
unit when a signal is received.
NOTE
• Avoid dropping or damaging the remote
control, using in a high humidity condition,
in direct sunlight or near a heat source.
1
2
3

Battery Information

E-9
Remove the back cover
Press and slide the back cover to
remove.
Insert batteries
Insert batteries with
shown below.
Close the back cover
Transmitter
and as
Receiver