Pour Water Into The Tank - Sharp FU-S63E Bedienungsanleitung

PREPARATION

Pour water into the Tank

This product can be used as an air purifier without putting water in the tank.
1
Hold the tank handle and remove the
tank.
Remove the tank cap and pour water.
2
• Use drinkable tap water.
(Generally speaking, tap water is sterilized with
chlorine to suppress propagation of bacteria.)
• Change the tank water every day with fresh tap
water.
After supplying water, securely
3
tighten the tank cap.
• Check to see that there is no water leak.
• Be sure to wipe off any excess water around
the tank.
• When carrying the tank, hold it with both
hands so that the tank opening is facing up.
Mount the tank to the main unit.
4
• Insert the tank cap into the dented part of the
unit.
• Make sure the tank is firmly attached by
pushing it in until you hear a click.
CAUTION
• Do not expose the unit to water. Short circuit and/or electrical shock may occur as a result.
• Do not use hot water (of 40˚C or higher), chemical agents, aromatic substances, dirty water,
etc. Deformation and/or malfunction may occur as a result.
• Do not use mineral water, ionized alkaline water, well water, purified water, etc. Propagation
of mold fungus and bacteria may occur as a result.
• Securely tighten the tank cap. If the tank cap is difficult to tighten, loosen the cap one full turn
to properly set the cap to the tank.
Tank Cap
Tank Cap
E-8
Tank Handle
Tank
Tank