Opening The Door; Closing The Door - Format Rubin Pro Betriebs- Und Montageanleitung

Operating and mounting instructions
In buying this safe, you have chosen a quality product with tested security. These instructions describe how to operate
and mount your safe.
Please read these instructions carefully before putting your safe into operation, and keep the instructions in
a secure place outside the safe!
Scope of the instructions
Rubin Pro series safes.
Resistance Grade III according to DIN EN 1143-1.
The type plate (plaque) indicating the model designation and identification number is located inside the door at the top.
Please provide this information if you have any queries. Make a note of the information on the type plate and enclose it
with the instructions.
Recommended insurance sum: 200,000 € for private use, 100,000 € for commercial use.
Please clarify the exact sums insured with your insurance company.
1. Manufacturer's instructions for safe operation:
•
Before the initial start-up (opening the safe door), please make sure that the safe is correctly set up. The safe
must also be secured against tilting.
•
When closing the safe door, make absolutely sure that there are no limbs between the safe door and the safe
body. Otherwise there is a risk of crushing of trapped limbs.
•
Before closing the safe door, make sure that the locking bolts in the safe door are retracted. Extended latch bolts
bump against the safe body when the door is closed, causing the locking mechanism to become damaged and
malfunction.
•
Tamper protection: To prevent unnoticed tampering inside the door, the door panel is equipped with a seal.
•
With the key lock version, keep the keys in a safe place, but not in the
safe!
•
If the code lock is used, write down the numerical code and keep it in a safe place,
but not in the safe!

WARNING! DANGER TO LIFE!
There is a danger of suffocation from packaging and protective films. Keep packaging and protective films away from
children.
2. Operation

2.1 Opening the door

Safes with a double-bit key lock:
Insert the key and turn it clockwise as far as it will go, then turn the door handle fully clockwise and pull the door open.
On 2-door models, the left-hand door can also be opened with a door handle (turn door handle to the left).
Please note that double-bit keys have two different sides (bits). When inserting the key into the keyhole,
the longer side must point towards the door handle.
Safes with a mechanical code lock:
This combination lock comes with its own operating instructions.
Important: Please change the pre-set factory code and replace it with a personal code.
To change the factory code, there is a hole in the door trim at the level of the lock, please remove the cover cap over the
hole and insert the changeover key into the combination lock.
The door trim does not have to be removed for this!
Safes with an electronic code lock:
This code lock comes with its own operating instructions.
Important: Please change the pre-set factory code and replace it with a personal code.

2.2 Closing the door

Safes with a double-bit key lock:
Close the door firmly, turn the door handle anticlockwise all the way to the left and turn the key anticlockwise to the left.
Now pull the key out of the door.
For 2-door models, follow the procedure below: Press the left door firmly shut, lock the left door handle (turn the door
handle to the right). Push the right-hand door firmly shut, turn the door handle anticlockwise all the way to the left and
turn the key anticlockwise to the left as well. Now pull the key out of the right-hand door.
Important! Make sure that the door is properly locked.
11.07.2024 / A1014188
Rubin Pro - Safe
DE/EN/FR/NL
9