Maintenance And Service - Format Rubin Pro Betriebs- Und Montageanleitung

Operating and mounting instructions
4. Limitation of liability / Expiry of certification
Consequential damage following attempted break-ins, fires and improper tampering with the structure and function of the
safe will invalidate the certification and warranty. We shall not be liable for malfunctions caused by the use of force or
improper handling, and not for property damage or financial losses which are attributable, for example, to the improper
locking of the safe. In case of malfunctions, repairs may only be carried out by companies authorised by the
manufacturer.
There is a white security seal on the door panel of each safe door when delivered. When dismantling the door trim
(repair, maintenance, etc.), the seal must be removed; it will be destroyed in the process. When fitting the door trim, a
new seal must then be affixed. Please make the gluing area absolutely grease-free before gluing.
Only companies authorised by the manufacturer (service technicians) receive these seals. A destroyed seal, therefore,
indicates that the door trim panel has not been opened properly, which may invalidate the certification.
5. Preliminary setup/installation of burglar alarm system components
The Rubin Pro* safe series is set up for the installation of monitoring components which allow connection to a burglar
alarm system. A data sheet for approved burglar alarm system components and their installation and operating
instructions for the system installer are provided with the safe.
Installation (if a device is being fitted), connection, fine adjustment and commissioning of the components for the burglar
alarm system is always carried out on site by the customer's own burglar alarm system installer.
*Note:
Rubin Pro 3 and Rubin Pro 5 are supplied without pre-fitting for installing EMA components. They only have a cable
gland in the rear wall which can be used to establish a connection to a burglar alarm system after the safe has been
installed.

6. Maintenance and service

The bolt mechanism and the lock are maintenance-free.
If faults occur that you cannot correct yourself or if you have any further questions, please contact your safe dealer or
the manufacturer of your safe directly:
FORMAT GmbH
Industriestraße 10-24
D-37235 Hessisch-Lichtenau
Tel. 05602/939 818 or 819
www.format-tresorbau.de
7. Disposal
If at any time you intend to dispose of your safe, please remember that many components of the safe are made of
valuable materials that can be recycled.
Batteries or accumulators with this symbol contain harmful substances.
Declaration of conformity: Products marked with this symbol comply with all applicable
Community rules of the European Economic Area.
Dispose of the packaging according to its type. You can also obtain information on waste disposal from
your municipal authority.
11.07.2024 / A1014188
Rubin Pro - Safe
DE/EN/FR/NL
12