Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Instructions d´utilisation et d´installation
In buying this safe, you have chosen a quality product with tested security. These instructions describe how to operate
and mount your safe.
Please read these instructions carefully before putting your safe into operation, and keep the instructions in
a secure place outside the safe!
Scope of the instructions
Built-in safe Wega Resistance Grade 1 as per EN 1143-1
The type plate (depending on the safe, a VdS plate or ECB.S plate) with details of the model designation, the
identification number and the resistance grade is located inside the top of the door. Please provide this information if you
have any queries. Make a note of the information on the type plate and keep it with the instructions.
The recommended insurance cover depends on the resistance grade of your safe. If you wish to insure the contents of
your safe, please clarify the exact cover/conditions with your insurance company.
1.
Manufacturer's instructions for safe operation:
•
Before using for the first time (opening the safe door), make absolutely sure that the wall safe is strongly top-
heavy before setting it in concrete. It is essential to secure the wall safe against tipping before opening it for the
first time.
•
When closing the safe door, make absolutely sure that there are no limbs between the safe door and the safe
body. Otherwise there is a risk of crushing of trapped limbs.
•
Before closing the safe door, make sure that the locking bolts in the safe door are retracted. Extended latch bolts
bump against the safe body when the door is closed, causing the locking mechanism to become damaged and
malfunction.
•
Tamper protection: To prevent unnoticed tampering inside the door, the door panel is equipped with a seal.
•
With the key lock version, keep the keys in a safe place, but not in the
safe!
•
If the code lock is used, write down the numerical code and keep it in a safe place,
but not in the safe!
WARNING! DANGER TO LIFE! There is a danger of suffocation from packaging and protective films. Keep
packaging and protective films away from children.
2.
Operation
NOTE: Check the proper functioning of your safe (opening and closing of the door) before setting it in concrete!
2.1 Opening the door
Safes with a double-bit security lock: (Standard version with door hinge on the right)
Insert the key and turn it clockwise as far as it will go, then turn the door handle fully clockwise and pull the door open.
Please note that double-bit keys have two different sides (bits). When inserting the key into the keyhole, the
longer side must point towards the door handle.
Safes with a mechanical code lock:
This combination lock comes with its own operating instructions.
IMPORTANT: Please change the pre-set factory code and replace it with a personal code.
To change the factory code, there is a hole in the door trim at the level of the lock, please remove the cover cap over the
hole and insert the changeover key into the combination lock.
The door trim does not have to be removed for this!
Safes with an electronic code lock:
This code lock comes with its own operating instructions.
IMPORTANT: Please change the pre-set factory code and replace it with a personal code.
22.07.2024 / A1014193
WEGA - Coffre-fort
mural
DE/EN/FR/NL
5 von 16
Werbung
