Safety And Information Signs; Hazards And Safety Provisions During Transport - Angelo Po 0S0Fa0 Handbuch

ENGLISH
The position of the signs provided is shown in
the picture.
Manufacturer and appliance nameplate.
A)
WARNING: read the manual carefully
B)
before carrying out any procedure.
WARNING: when washing the appli-
C)
ance, do not point pressurised water jets at in-
ternal parts.
WARNING draws attention on compli-
D)
ance with the rules. "Install in compliance with
the applicable regulations and use in well venti-
lated premises only".
WARNING draws the attention on
E)
compliance with the rules. "The Manufacturer
declines all liability in case of failure to comply
with the installation and commissioning in-
structions".

HAZARDS AND SAFETY PROVISIONS DURING TRANSPORT

During transport of the appliance, watch out for the following hazards and provide for the counter-
measures indicated below:
► Source of hazard: Handling of heavy loads
Hazard
Risk of injury due to
body overload
4

SAFETY AND INFORMATION SIGNS

Where or in which situations
does the hazard occur?
• When the appliance moves • Use a suitable lifting
E
D
F
37M3202
C B
WARNING: watch out for hot surfaces.
F)
CE Marking: it indicates that the equipment is
G)
compliant with all relevant laws applicable to
the product.
Countermeasures
device
• Observe the
values for lifting and
transport
• Wear personal protec-
tive equipment
SAFETY
G
A
Safety device
• PPE as required
by the applicable
laws in the coun-
limit
try of use.
3386371_ut_GB