Faults; Troubleshooting - Angelo Po 0S0Fa0 Handbuch

FAULTS

Clean every part of the hob with a suitable
8)
de-greaser.
Dry the surfaces and reassemble the parts. For
9)
the correct assembly of the burner (B) and
burner cap (A), follow the directions given in
the fi gure.
Turn on the burners for a few minutes to en-
10)
sure a thorough drying and thus avoiding the
formation of rust.
The appliance has been tested before commis-
sioning. The information provided below is in-
tended to help identify and correct any anoma-
lies and malfunctions which might occur during
use.
Some of these issues may be resolved by the
user, whereas other issues require specifi c tech-
nical knowledge or skill, and therefore they
must be dealt with by qualifi ed staff with rec-
ognised experience acquired in the specifi c sec-
tor of operation.
Issues
Smell of gas
The pilot light does not
light up
The pilot light goes off .
The fl ame is yellow.
Burner control knob is stiff .
3386371_ut_GB
such as the burners, burner caps and grids in
a dishwasher.
dirt to fall into the burner as this will cause a
fault in the burner or block the nozzle.
FAULTS

TROUBLESHOOTING

For any need, please contact Angelo Po's
agents or headquarters, which can be found
in the contacts section of the website www.
angelopo.com.
Causes
Occasional leak because
fl ame has gone off .
Air in pipelines due to long
period of downtime.
The thermocouple has not
heated up enough.
Burner dirty
Gas control valve fault.
WARNING: Do not wash cast iron parts
WARNING: Never pour water or allow
NOTE
:
Remedies
Turn off the gas supply tap and
ventilate the room
Make more attempts
to light the fl ame.
Make more attempts
to light the fl ame.
Clean the burner
NOTE: Contact the af-
ter-sales service.
ENGLISH
21