CTEK RB 3000 BOOSTER Bedienungsanleitung Seite 6

USAGE
Press and hold the Power Button for 2 seconds to switch the Booster on.
INTERNAL BATTERY CHARGE
The Booster is supplied partly charged, so you will need to charge the internal
battery before use. Ensure this is done indoors and not outside.
To charge the Booster - insert the USB-C cable into the side of the booster and
the USB-C into a compatible mains adapter (sold separately by CTEK).
Connect to a suitable mains outlet to begin charging.
CAUTION! Never leave the product unattended for long periods of time
while charging.
Disconnect the mains adapter when fully charged.
IMPORTANT! Regularly recharge the booster to avoid discharging the battery.
CHARGING OTHER DEVICES
Plug the supplied USB-A or USB C cable into the device you would like to charge
and the other end into the USB port or the Quick Charge (PD 30W) outlet port.
The Quick Charge (PD 30W) outlet port will recognize your device and charge it
accordingly.
Press the Power button to start. You will notice the lightning icon appears on the
display to indicate charge is in progress. Disconnect when fully charged.
IMPORTANT! If the operating temperature gets too high, the Boosters
high-temperature protection will stop the charge.
USING THE LED FLASHLIGHT
Press and hold the Power Button to switch on the Booster.
To change modes, press the Power Button again.
There are 3 modes to choose - Steady, strobe and SOS.
To switch off, press and hold the Power Button.
IMPORTANT! If a low-voltage warning appears, charge before
long-term storage.
© CTEK SWEDEN AB WWW.CTEK.COM RB 3000 | USER MANUAL | 6