Dtmf Settting; Programming Software; Maintenance - Retevis Rt95 Bedienungsanleitung

setting. the menu value in LCD turns to green color.
4. Turn channel knob to choose wanted setting.
5. Press [PUSH] button or [P3] key to store setting and exit.
9. DTMF SETTING
9.1 DTMF Encode group setting
1. Enter DTMF menu. choose No.1 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting.1-16 total 16 groups DTMF encode for selection.
4. If choosed group is empty, Press PUSH to edit DTMF code, the LCD displays "= = = = = = = =".
5. Turn channel knob to choose wanted characator,press PUSH to confirm and move to next characator selection.
6. Press [P3] key to store setting and exit.
9.1 DTMF Encode Transmitting Time
1. Enter DTMF menu. choose No.2 function
2. Press [PUSH] button, the menu value in LCD turns to green color.
3. Turn channel knob to choose wanted setting.
50MS: The time for transmit a single DTMF encode and the interval is 50MS,
100MS: The time for transmit a single DTMF encode and the interval is 100MS,
200MS: The time for transmit a single DTMF encode and the interval is 200MS,
300MS: The time for transmit a single DTMF encode and the interval is 300MS,
500MS: The time for transmit a single DTMF encode and the interval is 500MS.
4. Press [PUSH] button or [P3] key to store setting and exit.
10. PROGRAMMING SOFTWARE INSTALLING AND STARTINGSOFTWARE I
Install USB Cable Driver Programme
1. Click start menu in computer, under "ALL PROGRAMS" menu, choose and click "USB To Com port" in MT95 program,
install "USB To Com port" driver by indication.
2. Connect the optional USB Programming cable to USB port in PC with transceiver.
3. Double click MT95 shortcut or click MT95 inprocedure index of start menu, choose serial com port as indicated then click
OK to start programming software.
4. According to instruction,select correct"COM Port", then click "OK" to start programming software.
» Even in same computer,the selective COM Port is different when USB cable connects with different USB port.
You shall install software before connecting the USB cable line. Switch on transceiver before writing frequency.You had
better not switch on or off the power supply of transceiver when it is connected with computer, otherwise, it will make
transceiver unable to read or write frequency. In this case, you have to turn off programming software, pull out USB cable.
then reinsert USB cable and open software, then rechoose COM Port, it will turn into normal operation. Therefore, please
connect transceiver with computer after switching on the transceiver. Don't restart transceiver power when it is connected
with computer.

11. MAINTENANCE

11.1 Default Setting after Reset
Frequency band
VFO frequency
Memory channel
Offset direction
Offset frequency
Channel step
CTCSS encode and decode
CTCSS tone frequency
DCS encode and decode
DCS Code
Output power
TOT
APO
VOL
Squelch Level
VHF
145.150MHz
--
--
600KHz
10KHz
--
88.5Hz
--
000N
HI
3
OFF
28
3
15
UHF
431.150MHz
--
--
5KHz
10KHz
--
88.5Hz
--
000N
HI
3
OFF
28
3