Mic Connector Diagram(In The Front View Of Connector); Mode Set; Display Mode - Retevis Rt95 Bedienungsanleitung

3.4 Microphone
1
2
10
NO. Key
1 UP
2 DOWN
3 PTT
4 Number Key
5 A/B band
6 Band indicator
7 TX/RX indicator
8 MIC
9 Speaker
10
Lock UP/DOWN

MIC Connector Diagram(in the front view of connector)

4.MODE SET

1.Display Mode

How to choose display mode by PC programming: In PC software's "Function Setup" menu, the
"Display Mode" selection available setting: "Frequency" , "Channel" or "Name" How to choose
display mode by radio menu: Please refer to "Display Mode" in Page 17.
A.Frequency mode: When set display as'Frequency", new setting of channel operation and shortcut
operation can be temporarily used by user. Once the radio is turned off or switched to another
channel, the temporary setting will be erased and back to initial settings.(As pic 1)
7 8
5
Funktion
Increase frequency, channel number or setting value
DOWN Decrease frequency, channel number or setting value
PTT Press the PTT (Push-TO-Talk) key to transmit
Number Key Input VFO frequency or DTMF dial out etc.
A/B band Choose left band or right band as Main band
Band indicator The indicator light on for Main band
TX/RX indicator Light green while receiving, Light red while transmitting
MIC Speak here during transmission
Speaker When shut the speaker in the base, you can hear the
calling by this speaker
10 Lock UP/DOWN When this key is in up position, It is unlock
UP/DOWN key, when this key is in down poisition, UP/DOWN
key will be locked
Kev Pad Serielle Daten
+5V
Down
UP
MIC GND
MIC
PTT
GND
4
6
9
6
3
(As pic 1)