Replacing Fuses; Antenna Connection - Retevis Rt95 Bedienungsanleitung

♦ Use the full length of the cable without cutting off excess even if the cable is longerthan required. In particular, never
remove the fuse holders from the cable.
5. Reconnect any wiring removed from the negative terminal.
6. Connect the DC power cable to the transceiver's power supply connector.
♦ Press the connectors firmly together until the locking tab clicks.
2.2.2 Fixed Station Operation
DC power supply,Please contact local dealer to require.The recommended current capacity of your power supply is 12A.
1.Connect the DC power cable to the regulated DC power supply and ensure that the polarities are correct. (Red: positive,
Black: negative).
♦ Do not directly connect the transceiver to an AC outlet.
♦ Use the supplied DC power cable to connect the transceiver to a regulated power supply.
♦ Do not substitute a cable with smaller gauge wires.
Regulated power supply
2.Connect the transceiver's DC power connector to the connector on the DC power cable.
♦ Press the connectors firmly together until the locking tab clicks.
» Before connecting the DC power to the transceiver, be sure to switch the transceiver and the DC power supply OFF.
» Do not plug the DC power supply into an AC outlet until you make all connections.

2.2.3 Replacing Fuses

If the fuse blows, determine the cause, then correct the problem. After the problem is resolved, replace the fuse. If newly
installed fuses continue to blow, disconnect the power cable and contact your authorized
authorized
Fuse Location
Transceiver 10A
Supplied Accessory DC
power cable
Only use fuses of the specified type and rating, otherwise the transceiver could be damaged.
» If you use the transceiver for a long period when the vehicle battery is not fully charged, or when the engine is OFF,
the battery may become discharged, and will not have sufficient reserves to start the vehicle.Avoid using the
transeceiver in these conditions.

2.3 Antenna Connection

Before operating,install an efficient, well-tuned antenna. The success of your installation will depend largely on the type of
antenna and its correct installation. The transceiver can give excellent results if the antenna system and its installation are
given careful attention.Use a 50 impedance antenna and low-loss coaxial feed-line that has a characteristic impdeance of
50,to match the transceiver input impedance,Coupling the antenna to the transceiver via feed-lines having an impedance
Regulated power supply
Black
DC power cable with fuse holder
servicecenter for assistance.
Fuse Current Rating
Red
Black
Red
10A
10A
2
dealer or an