Operation; Information On Sawing; Inserting And Removing The Battery; Switching On And Off - Parkside Performance Psspa 20-Li F4 Originalbetriebsanleitung

GB
MT

Operation

Information on sawing

Selecting a stroke rate
The stroke rate can be adjusted in 6 steps
with the stroke rate button (25). Start with a
low stroke rate. As a rule of thumb:
Material
Hard
Soft
The automatic load detection A allows a
more precise cut: The stroke rate is reduced
when idle. The stroke rate is only set to the
highest value when the workpiece is entered.
Selecting pendulum motion
The larger the pendulum motion, the faster
your progress.
Optimal pendulum motion can be estab-
lished through practice; the following set-
tings are recommended:
• For thin material, hard material (e.g. met-
al) or for cutting curves: Level 0
• Fine and clean cutting edges can be
achieved with little or no pendulum mo-
tion: Level 0 or 1
• Soft material (wood, plastic, etc.): Level 2
or 3
The label shows examples on the setting:
0 metal
1 Plastic pipe
2 Thin wood
3 Thick woode.g. metal
Plunge sawing
Requirements
• Soft materials such as wood, aerated
concrete, plasterboard etc.
• Mitre angle: 0°
• Short saw blade mounted
Procedure (Fig. F)
1. Place the device with the front edge of
the footplate (12) on the workpiece. The
saw blade (16) does not touch the work-
piece.
2. Turn the device on. Wait until the maxim-
um stroke rate has been reached.
28
Stroke rate
Low
High
3. Press the saw blade (16) into the work-
piece until the footplate (12) rests on the
workpiece.
4. Continue sawing along the cutting line.
General Information
With this order, you work safely with the
sabre saw and achieve a good result:
1. Clamp the workpiece. Use a clamping
device for small workpieces.
2. Draw a line to specify the direction in
which the saw blade is guided.
3. Hold the device securely by the handle.
4. Set the stroke rate.
5. Set the mitre angle.
6. Set the stroke strength.
7. Turn the device on.
8. Wait until the device has reached its full
stroke rate.
9. Place the footplate on the workpiece.
10. Slowly move the device along the
marked line, pressing the footplate firmly
down onto the workpiece.
11. Do not apply too much pressure in the
cutting direction. Let the device do the
work.
12. Before shutting down the device, switch
it off and wait for it to come to a com-
plete standstill.
Inserting and removing the
battery
WARNING! Risk of injury due to uninten-
tional start-up. Only insert the battery into
the device once the device is fully prepared
for use.
NOTICE! Risk of damage! An incorrect bat-
tery can damage the device and battery.
Inserting the battery
1. Push the battery (9) along the guide into
the battery holder (8).
You will hear the battery click into place.
Removing the battery
1. Press and hold the battery release (30) on
the battery (9).
2. Pull the battery out of the battery holder
(8).

Switching on and off

Switching on
1. Insert the rechargeable battery (9) into
the device.
2. Press the unlock button (3).