Dispose Of Batteries In An Environmentally Friendly Manner; Troubleshooting - Parkside Performance Psspa 20-Li F4 Originalbetriebsanleitung

GB
MT
This does not affect accessories enclosed
with the old devices or tools without any
electrical components.
Dispose of batteries in an
environmentally friendly manner
Do not throw batteries into domestic
waste, fire (risk of explosion) or wa-
ter. Damaged batteries can harm the
environment and your health if pois-
onous fumes or liquids escape.
You are obliged to dispose of defective or
used batteries in an environmentally friendly
manner.
• Do not open the batteries and avoid
mechanical damage. There is a risk of a
short circuit and vapours may leak out,
causing irritation to the respiratory tract.

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Device works with in-
terruptions
Poor sawing perform-
ance
30
Possible Cause
Rechargeable battery (9) not
inserted
On/Off button (2) defective
Rechargeable battery (9) dis-
charged
Defective motor
Internal loose contact
On/Off button (2) defective
Saw blade (16/17) unsuitable
for the workpiece to be pro-
cessed
Saw blade (16/17) blunt
Low battery power
Incorrect sawing speed
• For safety reasons, batteries should be
discharged before disposal.
• Tape the poles to prevent short circuits.
• Dispose of rechargeable batteries via a
retailer or collection point.
• Damaged batteries
Handle externally damaged batteries with
particular care!
• Do not touch damaged batteries with
your bare hands.
• If you cannot tape the poles, place the
batteries individually in a plastic bag.
• Place damaged batteries individually
in a non-flammable, sealable container
that can still be filled with sand.
• Take damaged batteries to a collection
point with specialised personnel.
Remedy
Inserting the battery, p. 28
Contact the service centre.
Charge the battery (see the separ-
ate operating instructions for the re-
chargeable battery and charger)
Contact the service centre.
Contact the service centre.
Contact the service centre.
Use a suitable saw blade (16/17)
Use a new saw blade (16/17)
Charge the battery (see the separ-
ate operating instructions for the re-
chargeable battery and charger)
Adjust sawing speed