Air compressor
size & power
5-6 Gallons
8-11 Gallons
15+ Gallons
Always use clean, dry, regulated, compressed air at 4 to 7bar (60 to 100PSI).
Do not exceed the maximum and minimum pressure. Operating the tool at the
wrong pressure (too low or too high) will cause excessive noise or rapid wear.
It is recommended that a filter-regulator-lubricator be used and be located as
close to the tool as possible.
If a filter-regulator-lubricator is not installed, place up to 6 drops of pneumatic
tool oil into the air inlet plug before each use.
If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter
will reduce the air pressure to the tool, which will cause a reduction in power,
efficiency, and general performance.
2HP
Light duty and
intermittent use
Light duty and
intermittent use
Medium duty and
intermittent use
AIR SYSTEM
2-1/2 HP
Light duty and
intermittent use
Medium duty and
intermittent use
Heavy duty and
continuous use
3+ HP
Medium duty
and intermittent use
Heavy duty and
continuous use
Heavy duty and
continuous use