VEVOR RP7426 Originalanleitung Seite 13

Air-operated tools must be inspected periodically, and worn or broken parts

must be replaced in order to keep tools operating safety and efficiently.
Inspect and replace worn or damaged O-rings, seals, etc. Tighten all screws

and caps frequently in order to help prevent personal injury.
Loss of power or erratic action may be due to the following

- Excessive drain in the air line.
- Moisture or restriction in the air pipe.
- Incorrect size or type of hose connector. Check the air supply and follow
instructions.
- Grit or gum deposits in the tool may also reduce performance.
Inspect the trigger, the spring, and the safety mechanism for free movement

on a regular basis in order to ensure that the safety system is fully functional.
Verify that no part is loose or missing and that no part is stuck or jammed.

Disconnect the tool from the air supply, clean, and store it in a sale, dry, and

childproof location, when tool is not in use.
When temperatures are below freezing, keep tools as warm as possible using

any safe, convenient method.
Check the air supply for correct size and type of hose connectors. To avoid

loss of power or erratic action, ensure that there is no additional drain on the
air line and no moisture or restriction in the air pipe.
Storage:
Apply an ample amount of lubrication before storing the tool.

Run the tool for approximately 30 seconds after lubricating, in order to ensure

that the lubrication is uniformly distributed throughout the tool.
Store the tool in a clean and dry environment.

The following chart lists common issues and solutions. Please read it carefully

and follow all instructions closely.
WARNING!
Potential hazard that will result in serious injury or loss of life.
TROUBLESHOOTING