Air Supply - Vevor Rp9513 Bedienungsanleitung

Operating Instruction
Description
The durable twin hammer impact wrench mechanism features pressure-
feed lubrication, adjustable power regulator, variable speed, high torque,
side exhaust, sheer power, and performance to tackle the toughest jobs
with ease to proven durability and economy.

Air supply

1. Ensure wrench air valve (or trigger) is in the "off" position before
connecting to the air supply.
2.You will require an air pressure of 90psi, and an air flow according to
specification.
3. WARNING! Ensure the air supply is clean and does not exceed 90psi
while operating the wrench. Too high air pressure and unclean air will
shorten the product life due to excessive wear and may be dangerous,
causing damage or personal injury.
4.Drain the air tank daily. Water in the air line will damage the wrench.
5.Clean air inlet filter weekly.
6. Line pressure should be increased to compensate for unusually long air
hoses (over 8 meters). The hose diameter should be 3/8" I.D.
7.Keep the hose away from heat, oil, and sharp edges. Check the hose for
wear, and make certain that all connections are secure.
Lubrication
An automatic in-line filter-regulator-lubricator is recommended (Fig4) as it
increases tool life and keeps the tool in sustained operation. The in-line
lubricator should be regularly checked and filled with air tool oil.
Proper adjustment of the in-line lubricator is performed by placing a sheet
of paper next to the exhaust ports and holding the throttle open for
approximately 30 seconds. The lubricator is properly set when a light stain
of oil collects on the paper. Excessive amounts of oil should be avoided.
In the event that it becomes necessary to store the tool for an extended
period of time (overnight, on weekends, etc.), it should receive a generous
amount of lubrication at that time. The tool should be run for approximately
30 seconds to ensure the oil has been evenly distributed throughout the
tool. The tool should be stored in a clean and dry environment.