Loading and operation
DANGER!
Potential hazard that will result in serious injury or loss of life
Carefully read all instructions provided in this manual and understand them
thoroughly before using the tool.
Do not use Impact wrench accessories other than those that are specifically
designed for use with the Air-powered impact wrench. Failure to comply will
result in serious injury or loss of life.
Verify that the air supply is clean before operating the Air powered impact
wrench.
1. Plug in compressor, turn it on set the pressure regulator to 90psi, attach one
end of the air hose to the compressor and the other end of the air hose to the tool .
Use plumber's tape to avoid air leak ( see section" Technical specifications").
2. Place and lock the socket over the square drive of the Air-powered impact
wrench.
3. Place the socket over a nut to be removed or installed and press the trigger at
the top of the handle to operate the tool.
4. For reverse (R ) rotation, press the speed control knob on the left side of the tool;
For forward (F) rotation, press the speed control knob on the right side of the tool;
Rotate the speed control knob on the left side of the tool during reverse rotation to
control the speed of the air flow as required. Rotate the speed control knob on the
right side of the tool during forward rotation to control the speed of the air flow as
required.
5. After using the tool, disconnect the air hose from the tool.
WARNING!
Potential hazard that will result in serious injury or loss of life.
Hold the tool firmly with hands.
Do not apply additional or excessive force to the tool when working.
Do not allow the tool to run free for an extended period of time. Doing so will
shorten the life of the tool.
Verify that the air supply is clean and air pressure does not exceed 90psi
(6.3bar) while operating the tool. If the air pressure is too high or unclean, it
will shorten the life of the tool. Failure to comply could result in serious injury
or loss of life.