VEVOR RP17407 Originalanleitung Seite 6

toward the user or other personnel.
• Risk of inhalation: Never directly inhale the air produced by the
compressor.
•Risk of bursting: Do not adjust the pressure switch or safety valve for any
reason. They have been preset at the factory for this compressor's
maximum pressure. Tampering with the pressure switch or the safety valve
may cause personal injury or property damage.
•Risk of burns: The pump and the manifold generate high temperatures. In
order to avoid burns or other injuries, do not touch the pump, the manifold,
or the transfer tube while the compressor is running. Allow the parts to cool
down before handling or servicing. Keep children away from the
compressor at all times.
• Risk of bursting: Make sure the regulator is adjusted
so that the compressor outlet pressure is set lower than
the maximum operating pressure of the tool. Before
starting the compressor, pull the ring on the safety valve
to make sure the valve moves freely. Drain water from
tank after each use. Do not weld or repair tank. Relieve
all pressure in the hose before removing or attaching accessories.
WARNING!
Potential hazard that will result in serious injury or loss of life.
• Always ensure that the work piece is firmly secured leaving both hands
free to control the tool.
• Always keep your air tool clean and lubricated. Daily lubrication is
essential to avoid internal corrosion and possible failure.
Do not overload the tool. Allow the tool to operate at its optimum speed
•
for maximum efficiency. Excessive overload
can cause the tool casing to split, and may also lead to excessive wear on
moving parts and possible failure.
Use only the light weight coil hoses. For connecting the tool to the
•
compressor coupling. Do not fit quick change couplings onto the tool, as the
vibration can lead to damage or failure of the coupling.
Always ensure that the tool has stopped before connecting it to the air
•
supply.