void the compressor or tool guarantee/warranty
Air compressor size
& power
5-6 Gallons
8-11 Gallons
15+ Gallons
Always use clean, dry, regulated, compressed air at 6.3 to 8.3bar (90
to 120PSI).
Do not exceed the maximum and minimum pressure. Operating the
tool at the wrong pressure (too low or too high) will cause excessive
noise or rapid wear.
It is recommended that a filter-regulator-lubricator be used and be
located as close to the tool as possible.
If a filter-regulator-lubricator is not installed, place up to 6 drops of
pneumatic tool oil into the air inlet plug before each use.
If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty
filter will reduce the air pressure to the tool, which will cause a
reduction in power, efficiency, and general performance.
2HP
Light duty and
intermittent use
Light duty and
intermittent use
Medium duty and
intermittent use
AIR SYSTEM
2-1/2 HP
Light duty and
intermittent use
Medium duty and
intermittent use
Heavy duty and
continuous use
3+ HP
Medium duty
and intermittent use
Heavy duty and
continuous use
Heavy duty and
continuous use