Tool runs
. Motor parts jammed with
slowly. Air
dirt particles
flows slightly
. Power regulator in closed
from
position
exhaust
. Air flow blocked by dirt.
Tools will not
. One or more motor vanes
run. Air flows
stuck due to material
freely from
buildup.
exhaust
. 'O' rings throttle valve
Tool will not
dislodged from seat inlet
shut off
valve.
Note: Repairs should be carried out by a qualified person.
EXPLODED VIEW & PARTS LIST
. Check air inlet filter for blockage.
. Pour air tool lubricating oil into air inlet as per
instructions.
. Operate tool in short bursts quickly reversing
rotation back and forth where applicable.
■ Repeat above as needed.
. Pour air tool lubricating tool into air inlet.
. Operate tool in short bursts of forward and/or
reverse rotation where applicable.
. Tap motor housing gently with plastic mallet.
. Disconnect supply. Free motor by rotating
driveshank manually where applicable
. Replace O-rings or return to service center.