VEVOR RP17407 Originalanleitung Seite 14

In-depth
inspection
Replace worn or
broken parts
Lubrication
Lubrication: If the Air-powered impact wrench and the compressor are

not equipped with an in –line lubrication system, place up to 6 drops of
pneumatic tool oil into the air inlet before each work day or after every
2 hours of continuous use, depending on the characteristics of work
piece.
Air-operated tools must be inspected periodically, and worn or broken

parts must be replaced in order to keep tools operating safety and
efficiently.
Inspect and replace worn or damaged O-rings, seals, etc. Tighten all

screws and caps frequently in order to help prevent personal injury.
Loss of power or erratic action may be due to the following

- Excessive drain in the air line.
- Moisture or restriction in the air pipe.
- Incorrect size or type of hose connector. Check the air supply and follow
instructions.
- Grit or gum deposits in the tool may also reduce performance.
Inspect the trigger, the spring, and the safety mechanism for free

movement on a regular basis in order to ensure that the safety system
is fully functional.
Verify that no part is loose or missing and that no part is stuck or

jammed.
Disconnect the tool from the air supply, clean, and store it in a sale, dry,

and childproof location, when tool is not in use.
When temperatures are below freezing, keep tools as warm as

possible using any safe, convenient method.
Worn or broken
parts
See below
Pneumatic
tool oil