VEVOR RP17407 Originalanleitung Seite 12

Do not use oxygen or any other combustible or bottled gas to power

this tool.
Do not use this tool in the presence of any flammable liquids or gases.

Keep hose away from heat, oil, and sharp edges. Check hose for wear

and tear, and ensure that all connections are secure. Failure to comply
could lead to serious injury or loss of life.
Keep hands and other parts of the body away from the work areas

when connecting the air supply. Failure to comply could lead to serious
injury or loss of life.
Loading and operation
Carefully read all instructions provided in this manual and understand

them thoroughly before using the tool.
Do not use Impact wrench accessories other than those that are

specifically designed for use with the Air-powered impact wrench.
Failure to comply will result in serious injury or loss of life.
Verify that the air supply is clean before operating the Air powered

impact wrench.
1. Plug in compressor, turn it on set the pressure regulator to 90psi, attach
one end of the air hose to the compressor and the other end of the air hose
to the tool . Use plumber's tape to avoid air leak ( see section" Technical
specifications").
2. Place and lock the socket over the square drive of the Air-powered
impact wrench.
3. Place the socket over a nut to be removed or installed and press the
trigger at the top of the handle to operate the tool.
4. For reverse (R ) rotation, press the speed control knob on the left side of
the tool; For forward (F) rotation, press the speed control knob on the right
side of the tool; Rotate the speed control knob on the left side of the tool
during reverse rotation to control the speed of the air flow as required.
OPERATING INSTRUCTIONS