Switching The Balance On; Taring - Mettler Toledo AE163 Bedienungsanleitung

OPERATION: How to switch the balance on, and how to tare
The balance is tared by pressing the single contral bar; this bar also turns the display on and off. When switching the balance off by means of the control bar, only
the display is turned off. The electronic components are on as long as the power cable is connected (standby). This allows the balance to be operational at all times
and eliminates the need for a warm-up time.
Switching the balance on/off
Switching on:
– Briefly press control bar (1).
All display elements light up for several
seconds:
((((((((
This permits a functional check of the display.
Then, =0000 is displayed.
Switching off:
– Briefly lift control bar.
If the balance displays OFF the control bar must be
pressed again briefly.
Taring
– Place a container on the pan. Weight is
displayed.
– Briefly press control bar (1).
Display is blanked out, then =0000 appears.
The container weight is now tared out.
The selected weighing range is now available for
weighing-in, minus the tared-out container weight.
Brief Operating Instructions
Located beneath the balance is a swing-out card
(2) on which an abbreviated form of the Operating
Instructions are printed.
A detailed procedure (configuration cycle) is
illustrated on the next page.
5