4
Installation on the scale
In all installation work, refer to the following control drawing:
– Installation drawing 175823A according to CENELEC standard IEC 60079-15.
4.1 Attaching power cable to the scale
1
• Turn the scale on its side so that the
connection socket (1) is accessible.
• Route the cable from the PS-EX2P AC
adapter to the scale and plug connector
into the scale.
• Lock the power socket with the locking
device supplied (see lower figure). Make
sure the power socket can not be sepa-
rated from the scale without using a tool.
• Turn the scale back to the proper posi-
tion.
7