The Additional Master's Card - telekom behnke myintercom Plus Anleitung

Once again hold the master's card to the card
reader, while the display is flashing. The time
shown will be set, and the decimal point to the
right will turn on.
Now, you may remove the master's card from
the card reader. The display will turn off.
www.behnke-online.com
Instructions myintercom Plus IP video door intercom

5.4. The additional master's card

How to program the additional master's card
To ensure highest safety and security, only
Telecom Behnke GmbH can program the initial
master's card. For this reason, it should be kept
in a safe place.
It is possible to program any transponder as the
additional master's card. To do so, you need the
initial master's card provided.
Hold the initial master's card to the card reader.
The system will go through all the 190 ("
memory positions. Then the display will show
the following:
Remove the initial master's card from the card
reader. For approx. 3 seconds, the display will
remain lit, and then the display will flash for
about 6 seconds. Hold the transponder you
wish to program as the additional master's card
to the card reader.
The new transponder is now programmed as the
additional master's card, and the decimal point
to the right will turn on.
GB
Card reader
")
1.9
63