How To Set The Time For The Open Door Function - telekom behnke myintercom Plus Anleitung

Instructions myintercom Plus IP video door intercom
GB
Card reader
How to delete a transponder
Hold the master's card to the card reader and
select the memory position (cf. "5.1. Select a
memory position" on page 61).
A memory position is in use, when the decimal
point to the right is visible.
Remove the master's card from the card reader.
For approx. 3 seconds, the display will remain
lit, and then the display will flash for about 6
seconds. Once again hold the master's card to
the card reader, while the display is flashing.
The selected memory position will be deleted,
and the decimal point to the right will turn off.
62
5.3. How to set the time for the open
door function
You may set a time for the open door function
between 0.5 to 9 seconds. The default setting
for the open door function is 4 seconds.
Hold the master's card to the card reader. The
system will go through all the 190 ("
memory positions. Then the display will show
the following:
The times for the open door function will appear
in the following order:
= 0.5 seconds
H0
= 1 second
H1
...
= 9 seconds
H9
Remove the master's card from the card reader
when the displays shows the desired time. For
approx. 3 seconds, the display will remain lit, and
then the display will flash for about 6 seconds.
")
1.9
www.behnke-online.com