Installation - telekom behnke myintercom Plus Anleitung

Instructions myintercom Plus IP video door intercom
GB

Installation

installation
3.
The basic electronics for the door intercom
52
Ethernet socket
The LAN connection is usually made via an
RJ-45 connector . You may also connect the
individual cores using a terminal block
network is connected to the terminals marked
1 (orange-white); 2 (orange); 3 (green-white);
and 6 (green) according to EIA/TIA specification
568 B. The figure indicates the pin number for
the RJ-45 connector / the RJ-45 socket.
Alternative Ethernet connection
It is not admissible to establish a connection
by simultaneously using the socket and the
terminal block! This may cause damage to the
door intercom!
Connect the open door function
Connection option for one open door function
(12 V DC/AC max. 9 W). cf. chapter "3.3. Open
door/Relay/Gong" on page 55.
relay 1 (open door function relay)
Potential-free connection (maximum load
30 V DC / max. 1 A or 125 V AC / max. 0.5 A) to
hold the open door function to be activated
from the myintercom app. Cf. chapter "3.3.
Open door/Relay/Gong" on page 55.
relay 2 (additional relay)
Potential-free connection (maximum load
30 V DC / max. 1 A or 125 V AC / max. 0.5 A),
to be activated from the myintercom app.
Cf. chapter "3.3. Open door/Relay/Gong" on
page 55.
. The
www.behnke-online.com