Set A Door Gong - telekom behnke myintercom Plus Anleitung

Instructions myintercom Plus IP video door intercom
GB
Installation
Connect the door gongs to the terminals marked
"Gong". Button 1 controls gong 1, button 2
controls gong 2 ... the buttons are numbered in
an ascending order from top to bottom.
Important! To enable tamper protection, the
cover needs to be reattached to the housing
after connection!
56

3.4. Set a door gong

It is possible to assign a number of gong sounds
per time the button was pressed. The default
setting will make the gong sound twice when
the button is pressed once (setting 2). Turning
Gong 1
(on
the rotary control on the door intercom's elec-
site)
tronics allows you to set this number to values
between 0 and 9. When set to 0, no gong will
bell transformer
sound, but there will be a push notification on
(on site)
your device.
To turn the rotary control, please remove the
housing cover and turn the dial to the desired
value.
Important! To enable tamper protection, the
cover needs to be reattached to the housing
after connection!
www.behnke-online.com