VEVOR RC-9001 Originalanleitung Seite 5

the tool.
Carrying power tools with your finger on the switch or energizing power
tools that have the switch on invites accidents.
4. Remove any adjusting key or wrench before turning the power
tool on.
A wrench or a key left attached to a rotating part of the power tool may
result in personal injury.
5.
Do not overreach. Keep proper footing and balance at all times.
This enables better control of the power tool in unexpected situations.
6.
Dress properly. Do not wear loose clothing or jewelry. Keep
your hair, clothing and gloves away from moving parts. Loose
clothes, jewelry or long hair can be caught in moving parts.
7. Only use safety equipment that has been approved by an
appropriate standards agency.
Unapproved safety equipment may not provide adequate
protection. Eye protection must be ANSI-approved and breathing
protection must be NIOSH approved for the specific hazards in
the work area.
Power tool use and care
Do not force the power tool. Use the correct power
1.
tool for your application.
The correct power tool will do the job better and safer at the rate
for which it was designed.
2. Do not use the power tool if the
it on and off.
Any power tool that cannot be contr ol led wit h the switch
is dangerous and must be repaired.
3. Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing power tools.
Such pr eventi ve safety measur es reduce the ri sk of
start ing the power tool acci dentally.
4. Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
switch does not turn
- 4 -