HP LaserJet 3015 Faxhandbuch Seite 90

Cause
Media has jammed in the automatic document
feeder (ADF) input tray.
Print is skewed (crooked) because the media
input tray is overloaded.
Print is skewed (crooked) because the media
guides are incorrectly set, broken, or missing.
Print is skewed (crooked) because the media
weight or surface finish does not meet HP
specifications.
The device is printing curled or wrinkled pages
because of the heat produced during the laser
printing process.
The device is printing curled or wrinkled pages
when using the output bin.
The device is printing curled or wrinkled pages
because the media is not stored properly.
The device is printing curled or wrinkled pages
because the media has been in the input tray
too long.
88 Chapter 5 Troubleshooting
Solution
(HP LaserJet 3015 all-in-one) Using both
hands, pull the control-panel door toward you.
Remove any jammed media. Make sure that all
of the pieces of media are removed, and then
close the control-panel door.
(HP LaserJet 3030 all-in-one and HP LaserJet
3380 all-in-one) Remove the automatic
document feeder (ADF) input tray and open the
ADF cover. Use both hands to lift up on the two
handles on the jam cleanout part until the part
unsnaps. Rotate and lift out the cleanout part,
and then set it aside. Lift and hold the green
lever, and rotate the pick mechanism until it
stays open. Gently try to remove the page
without tearing it. If you feel resistance, go to the
next step. Open the flatbed scanner lid and
gently loosen the media by using both hands.
Close the lid to the flatbed scanner and then
lower the green lever on the automatic
document feeder (ADF). Reinstall the cleanout
part by pushing down on the two tabs until the
part snaps into place. Install the cleanout part
correctly, because future jamming might occur if
the cleanout part is not correctly replaced.
Remove some of the media from the input tray.
Verify that the guides are not adjusted too tightly
or too loosely against the paper. Check for
broken or missing guides, and replace them if
necessary.
Make sure that the media meets HP
specifications. See the HP LaserJet Printer
Family Print Media Guide at the following
website: http://www.hp.com/support/ljpaperguide.
Paper curl tends to relax as the paper cools
while resting on a flat surface. Make sure that
the media meets HP specifications. See the HP
LaserJet Printer Family Print Media Guide at the
following website: http://www.hp.com/support/
ljpaperguide.
Open the straight-through output door on the
back of the printer and use this paper path.
Change the fuser mode back to the default or to
a different paper type.
When possible, store media in its sealed ream
at room temperature.
Turn over the stack of media in the tray or rotate
the media 180 degrees in the paper tray.
ENWW