HP LaserJet 3015 Faxhandbuch Seite 14

To connect the device to a jack that controls one telephone line
Complete the following steps to connect the device to a single telephone jack that controls
one telephone line, even if you have two telephone numbers on that line and use a ring-
pattern service (such as distinctive ring).
1. If a telephone cord is plugged into the telephone jack, unplug the cord and set it aside.
2. Open the print-cartridge door, and then open the left side panel to reveal the fax ports.
3. Take the fax cord that is included with the device and plug one end of it into the device
You must use the fax cord that came with the device in order to ensure that the device
Note
functions correctly.
4. Close the left side panel, and then close the print-cartridge door. When closing the left
5. Plug the other end of the fax cord into the telephone wall-jack.
If you want to connect additional devices (such as a telephone, an answering machine, or a
caller-ID box) to the telephone line, see
If you do not want to connect any additional devices, see
12 Chapter 1 Fax Setup
"line" port (the port that is marked with an "L").
side panel, make sure that the fax cord is routed through the upper notch in the panel.
Connecting additional
Specifying the fax
devices.
settings.
ENWW