HP LaserJet 3015 Faxhandbuch Seite 88

Issue
Outgoing fax calls continue to
be dialed.
Faxes that you send are not
arriving at the receiving fax
machine.
You cannot dial all of the
numbers in a long fax number.
Faxes you send include a
block of gray shading at the
end of each page
Faxes you send have data
missing from the end of each
page
86 Chapter 5 Troubleshooting
Cause
The device automatically
redials a fax number if the
redial options are set to On.
The receiving fax machine
might be off or might have an
error condition, such as being
out of paper.
The originals might be
incorrectly loaded.
A fax might be in memory
because it is waiting to redial a
busy number, other jobs that
are ahead of it are waiting to
be sent, or the fax is set up for
a delayed send.
The maximum number of digits
or characters that can be
entered into a fax number is 50.
You might be sending a fax
from the flatbed scanner (HP
LaserJet 3030 all-in-one or HP
LaserJet 3380 all-in-one only)
with the glass-fax size set
incorrectly.
You might be sending a fax
from the flatbed scanner (HP
LaserJet 3030 all-in-one or HP
LaserJet 3380 all-in-one only)
with the glass-fax size set
incorrectly.
Solution
To stop the redials while the
device is dialing, press
CANCEL
To cancel a pending fax job,
see Canceling a fax job. See
Changing the redial settings
change the redial setting.
Call the recipient to make sure
that the fax machine is on and
ready to receive faxes.
Make sure that the original
documents are correctly loaded
into the automatic document
feeder (ADF) input tray or
flatbed scanner (not available
with the HP LaserJet 3015 all-
in-one). See Loading originals
to fax
If a fax job is in memory for any
of these reasons, an entry for
the job appears in the fax log.
Print the fax activity log (see
Printing the fax activity log) and
check the Status column for
jobs that show a Pending
designation.
Try manually dialing the fax
number. See Using manual
Make sure the setting is
correct. For more information,
see Changing the default glass-
size setting.
Make sure the setting is
correct. For more information,
see Changing the default glass-
size setting.
ENWW
.
to
dial.