Operation Clts40Ww - Cameo TS 40 WW Bedienungsanleitung

7
ZOOM
Knurled knob for adjusting the beam size (right stop = maximum beam size, left stop = minimum beam size).
8
SAFETY EYELET
Overhead installation should only be carried out by trained personnel. The spotlight must be secured with appropriate safety ropes to
prevent falling.

OPERATION CLTS40WW

NOTE:
When the spotlight is properly connected to the mains, the following information appears successively on the display during the startup
process: "Update Wait ..." (only for service purposes), "Welcome to Cameo", "Fresnel" and the software version. After this step, the spot is
ready for operation and the operating mode that was previously selected is activated.
MAIN DISPLAY DMX MODE
In the upper line of the display, "DMX Addr" is displayed and in the lower line the currently set DMX start address. As soon as the DMX sig-
nal is interrupted, the display starts flashing; if the DMX signal is present again, the display stops flashing. The main display is automatically
activated if no input is made within about 30 seconds.
MAIN DISPLAY STANDALONE MODE
In the lower line of the display, the currently set operating Standalone mode is displayed (e.g. Slave, Static). The main display is automati-
cally activated if no input is made within about 30 seconds.
6
8
7