Connections, Controls And Indicators; Control Buttons - Cameo TS 40 WW Bedienungsanleitung

CONNECTIONS, CONTROLS AND INDICATORS

POWER IN:
1
100-240 V AC, 50-60 Hz
2
FUSE:
T1AL / 250 V DMX IN
1
POWER IN
Firmly connected 1 meter power cable with plug (CEE 7/7). Operating voltage 100 - 240 V AC / 50 - 60 Hz.
2
FUSE
Fuse holder for 5 x 20 mm fine-wire fuses IMPORTANT INFORMATION: Replace the fuse only with a fuse of the same type and rating. If the
fuse blows repeatedly, please contact an authorised service centre.
3
DMX IN
3-pin male XLR socket for connection of a DMX controller (e.g. DMX console).
4
DMX OUT
3-pin female XLR socket for looping through the DMX control signal.
5
BACKLIT LC DISPLAY
Displays the operating mode and other system settings.
6

CONTROL BUTTONS

MENU
Pressing MENU will take you to the selection menu for system settings. Repeatedly pressing MODE takes you back to the main display.
ENTER
Makes it possible to change a value and confirm changes.
UP and DOWN buttons
Press the UP and DOWN buttons for example, to adjust the DMX address or the system settings.
3 4
DMX OUT
MENU
6 5
ENTER
UP
6
DOWN
5