Device Information - Cameo TS 40 WW Bedienungsanleitung

Settings
Display = Display lighting
DMX Fail = Operation status with DMX signal interruption
DimCurve = Dimmer Curve
DimResp. = Dimmer response

DEVICE INFORMATION

Pressing MENU will take you to the selection menu for system settings. Using UP and DOWN, select the menu item "Sys Info" and confirm
with ENTER. You will then be taken to the sub-menu to display the device information. Use the UP and DOWN panels again to select the
desired sub-menu item and then press ENTER to retrieve the information (see table). Press MENU once more to return to the main display.
The main display is automatically activated if no input is made within about 30 seconds.
Sys Info
Temp = Temperature display of the LED unit
Op.Hours = Operating time display
Firmware = Displays the device software version
8
Backlight ON permanently on
Backlight Off deactivation after approx. 30 seconds of
inactivity
Hold last DMX command is held
Blackout activates Blackout
Linear The light intensity increases linearly with the
DMX value.
Exp Adjustment of the light intensity is finer in the
lower DMX value range and coarser in the
upper DMX value range.
Log The light intensity can be adjusted coarsely in
the lower DMX value range, and finely in the
upper DMX value range.
S Curve The adjustment of the light intensity is finer
in the lower and upper DMX value ranges and
coarser in the middle DMX value range.
LED The spotlight responds abruptly to changes in
the DMX value.
Halogen The spotlight behaves in a manner similar to
that of a halogen lamp with gentle changes
in brightness.
Temp LED xxC / xxF
Temp C°/F° °C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
Hour Total Displays the total operating time in hours
Vx. xx