Maintenance Schedule; Decommissioning / Recycling; Ec Declaration Of Conformity - Weber Rescue Systems B 10 Betriebsanleitung

ATTENTION!
Prior to all maintenance work, the appliances must be cleaned of any dirt so that
this does not get into the hydraulic system. Cleaning can be done with a conven-
tional citrus-based cleaner.
NOTE!
After underwater use in salt water, the device must be completely taken apart
and cleaned. Completely cleaning the device is sufficient after use in fresh water.
9.3

Maintenance schedule

For an exact maintenance schedule with inspection intervals, regulations and reports, see DGUV
guideline 305-002, point 13 (hydraulically-actuated rescue appliances).
NOTE
If problems occur when maintaining the appliances, our customer service
department is available to assist (see Chapter 1.6).
10

Decommissioning / recycling

After their operating life has expired, dispose of the appliances properly. However, individual parts can
be reused.
The hydraulic oil must be drained completely and caught. Note that hydraulic oil must be disposed of
separately!
The local disposal requirements are applicable to disposal of all equipment parts and packaging
materials.
Do not dispose of electrical tools with domestic waste! In accordance with European Directive 2002/96/
EC about old electrical and electrical appliances as implemented in national law, used electrical
appliances must be separately collected and passed on for environmentally responsible recycling.
NOTE
Please ask your supplier about disposal of the appliances.
86
11 EC Declaration of Conformity
EC-DECLARATION OF CONFORMITY
according to Directive 2006/42/EC
Herewith we declare, that our
LIFTING EQUIPMENT Büffel B 10
Lifting Kit H 1, Lifting Kit H 2,
Mini spreader SP 1
SBH 15-255, MSE 15-255
ACCESSORIES and all official Weber Rescue accessories to the tool
meets the relevant basic safety and health requirements of the Directive
EC-MACHINE DIRECTIVE 2006/42/EC
EC-DIRECTIVE RoHS 2011/65/EU
For the relevant implementation of the safety and health requirements mentioned in the directives, the
following standards and or technical specifications has been respected:
EN ISO 13857 : 2019 EN ISO 12100 : 2010
EN 13204 : 2016
The tool has been tested by a notified body (TÜV) according to:
UVV-VBG8 : 2010 DIN 15018 : 1984
DIN 18880 : 1991 EN 13204 : 2016
Authorised person to compile the technical file(s): Josef Eder - Head of Development
Losenstein, 05.08.2021
i.A. Hannes Buchner
(Productmanager)
INSATLLATION AND COMMISSIONING
WEBER-HYDRAULIK GMBH
Emil Weber Platz 1, A-4460 Losenstein, Austria
i. A. Josef Eder
(Head of Development)