Malfunction / Remedy; General Safety Instructions; Transport, Packing And Storage; Safety Instructions - Weber Rescue Systems B 10 Betriebsanleitung

5.12 Malfunction / remedy

Malfunction
Appliance does not reach full Control buttons were not pushed
performance all the way through
Appliance does not produce any During hose or coupling part
power or moves in the opposite replacement, oil pressure (P) was
direction to the one controlled switched with oil return (T)
Pressure build-up due to heating
Cylinder cannot be coupled Coupling halves are damaged or
heavily soiled
Oil leakage at the control handle Return hose is not properly
(hole between the hoses) coupled
Appliance not working despite
Pressure hose is not connected
operation of the control buttons
Lifter moves in opposite direction
Check valve defective
under load
Oil leak at the hoses or the hose Leakage of the hoses possibly due
bonding to damage
Degradation of the surfaces of Contact with aggressive, chemical
the hoses liquids
Oil leak at coupling parts Leakage from the coupling
5.13

General safety instructions

WARNING!
Danger of injury due to improper operation!
Improper operation can cause severe injury or property damage. Therefore,
always proceed as follows:
• For all work, observe the safety instructions and warnings given in chap-
ters 2 to 2.7.
• Carry out all work steps according to the information in these operating
instructions.
• Before starting work, ensure that all covers and guards are installed and
that they work properly.
80
Possible cause Remedy
Press the control buttons all
the way down
Carry out change, repair by
a specialist workshop
Drain some oil from the unit
using the pressure relief plug, see
Chapter 4.3
Move the shifting lever on
the power unit to the 0 position
and couple it correctly
Move the shifting lever on
the power unit to the 0 position
and couple it correctly
Have the device checked by
an authorized service centre
Change hoses, repair by
a specialist workshop
Change hoses, repair by
a specialist workshop
Change coupling halves, repair by
a specialist workshop
6

Transport, packing and storage

6.1

Safety instructions

CAUTION!
Damage due to improper transport!
Improper transport can cause considerable property damage.
Therefore:
• When unloading the packaged pieces, proceed with caution and pay atten-
tion to the symbols on the packaging.
• Only completely open and remove packaging at the actual storage site.
6.2

Transport inspection

Check the delivery immediately after receiving it for completeness and possible transport
damage so if needed, a remedy can be found quickly.
If there is any externally visible damage, proceed as follows:
• Refuse the delivery or accept it with reservation.
• State the extent of damage on the transport documents or the transporter's
delivery receipt.
• Initiate complaint.
NOTE!
Report every deficiency as soon as it is recognised.
Damage claims can be directed to our Customer Service (see Chapter 1.6).
LOAD LIFTER