Displayed Information And Symbols - VOLTCRAFT ET-100 Bedienungsanleitung

7. DISPLAYED INFORMATION AND SYMBOLS

The following is a list of symbols and information the measuring device can display.
MIN Min value display
MAX Max. value display
HOLD Data hold function is active
ZERO Zero adjustment symbol in the low-resistance and voltage measuring range
OL Overload; the measuring range has been exceeded
OFF Off position; the measuring device is switched off
Battery replacement symbol
Warning symbol for dangerous voltage (<30 V) at the test prods
Acoustic continuity check symbol
Backlight symbol
BATT Display of battery voltage in the measuring device (battery check)
V Direct voltage
V Alternating voltage
mV Millivolt (exp.-3)
V Volt (unit of electric voltage)
Ω Ohm (unit of electric resistance)
kΩ Kiloohm (exp.3)
MΩ Megaohm (exp.6)
LOCK Symbol for permanent measurement (in the insulation measuring range)
30