Clpa - Clock Parameters - Siemens SIPART DR19 Kurzanleitung

Quick Reference
(14) Signal lamp
(15) Signal lamp
(17) Signal lamp
Only the special details of the program controller are given here; the operations of
parameterization and configuring and other display possibilities remain
unchanged! Controls by digital signals are not described.
5.3

CLPA - Clock Parameters

Function Setting the program-specfic parameters and functions for the program controller/
program set station.
Step
Access to
1 Press button
the CLPA
"onPA" (selection level) displayed. Blocked if digital signals bLPS=1.
function
2 Press button
level). Blocked if digital signal bLS=1.
3 Press button
(configuring level). Controller now blocked and last value of y retained.
4 Using buttons
Selecting and
digital indicator.
changing
Quick step: Press one button after the other and remaining on both the
parameters
direction buttons (the first pressed determines the direction) parameters
will be let out in block at a time.
5 Press button
switched over.
6 Using buttons
(1) indicator.
Quick step: see step 4.
7 Press button
switched back.
8 Repeat steps 4 to 7 until all necessary parameters are set.
Exit to pro-
9 Press button
cess control
10 Press button
level
mode.
+
NOTE
For a program to be able to function, at least the PrSE, CLFO, t... and A...
parameters in the clock parameter list CLPA must be determined.
Configuring switches: S43 = 2, S23 = 8 (CB = "HIGH")
SIPART DR19
C73000-B7474-C140-06
Program setpoint w switched off via CB, clock stopped.
p
"Internal setpoint" (clock stopped, setpoint adjustable)
The complete program is -> 1 = PR1
shown here -> 2 = PR2
Procedure
(6) about 5 sec until "PS" flashes. Release button -
(8) several times until "CLPA" is displayed (selection
(9) about 3 sec until digital indicator SP-W (2) flashes
(7) or (8) select parameter names in the SP-W (2)
(6) once, indicator PV-X (1) flashes, input field is
(7) or (8). Modify the parameter value in the PV-X
(6) once, indicator SP-W (2) flashes, input field is
(13) once (selection level).
(13) once (process control level). Controller is in manual
Program Controller
89