Strs - Configuring Switches - Siemens SIPART DR19 Kurzanleitung

Quick Reference
Parameter
Setpoint start of scale
Setpoint full scale
Setpoint ramp time
Ratio factor - start
Ratio factor - end
Safety manipulated value
Split range left (Y1<Y2)
Split range right
Linearizer
output value
L-1 (-10%) to L11 (110%)
are equidistant
input vertices
1)
If S21 = 4, values are standardized on dA to dE.
3.3

StrS - Configuring switches

Contents Switches (software), which define how the instrument is configured.
Step
Accessing the
1 Press button
StrS list
"onPA" (selection level) displayed. Blocked if digital signal bLPS=1.
2 Press button
level). Blocked if digital signal bLS=1.
3 Press button
(configuring level). Controller now blocked and last value of y retained.
Select and
4 Using buttons
modify config-
digital indicator.
uring
switches
5 Press button
buttons 7, 8 operate on PV-X.
6 Using pushbuttons
(1) indicator.
7 Press button
switched back.
8 Repeat steps 4 to 7 until all desired parameters are set.
SIPART DR19
C73000-B7474-C140-06
Param.- Min Max
name
SA -10 % to 110 %
of dA, dE
SE
tS oFF/0.100 9984
vA 0.000 9.999
vE 0.000 9.999
YS -10.0 110.0
Y1 0.0 100.0
Y2 0.0 100.0
L-1 -10.0 110.0
L0 -10.0 110.0
L1 -10.0 110.0
L2 -10.0 110.0
L3 -10.0 110.0
etc. "
up to -10.0 110.0
L11
Procedure
(6) about 5 sec until "PS" flashes. Release button -
(8) several times until "StrS" is displayed (selection
(9) about 3 sec until digital indicator SP-W (2) flashes
(7) or (8). Select parameter names in the SP-W (2)
(6) once, indicator PV-X (1) flashes, adjustment
(7) or (8) Modify parameter values in the PV-X
(6) once, indicator SP-W (2) flashes, input field is
Configuring
Factory Eng.
setting unit
-5.0
105.0
oFF min
0.000 1
1.000 1
0.0 %
50.0 %
50.0 %
1)
-10.0 %
1)
0.0 %
1)
10.0 %
1)
20.0 %
1)
30.0 %
" etc. "
1)
up to %
110.0
59