Adap - End-Adaptation - Siemens SIPART DR19 Kurzanleitung

Configuring
3.7

AdAP - End-Adaptation

During adaptation the signal lamp ADAPT (16) flashes. The duration of the adap-
Adaptation
process
tation depends on the delay in the process.
You can switch from automatic to manual mode or from manual to automatic mode
during adaptation - press button
The adaptation process can be ended in the following ways:
End of
•
adaptation
Adaptation ended error-free (automatic);
•
Adaptation is aborted manually;
•
Adaptation is aborted automatically
If adaptation is ended in automatic mode:
Adaptation
is ended
Signal lamp AdAPT (16):
without
Operation and monitoring front:
error
Controller operating mode:
If adaptation is ended in manual mode:
Signal lamp AdAPT (16):
Operation and monitoring front:
Controller operating mode:
After switching to automatic mode, the controller operates according to the new
control parameters.
By pressing the exit button (13)
Adaptation
is aborted
Signal lamp AdAPT (16):
manually
Operation and monitoring front:
Controller operating mode:
The original control parameters are retained.
By error monitoring:
Signal lamp AdAPT (16):
Operation and monitoring front:
Controller operating mode:
80
Quick Reference
(9) once.
off
process control level
automatic mode,
the controller operates according to
the new control parameters.
off
process control level
manual mode,
the output manipulated value y
causes as small a control difference
as possible
off
process control level
manual mode (YS is output)
off
selection level l
manual mode (YS is output)
C73000-B7474-C140-06
SIPART DR19