Apst - All Preset - Siemens SIPART DR19 Kurzanleitung

Quick Reference
The following error messages may appear in the PV-X (1) and SP-W (2) displays:
Error message
SP.Pv (1)
SMAL (2)
over (1)
Shot (2)
n (1)
ModE (2)
Si (1)
ModE (2)
To exit the adaptation function:
Press button
Manual mode with YS remains operational.
3.8

APSt - All Preset

Function Controller is reset to factory setting.
+
NOTE
All settings are restored to their original factory settings. The APSt function can-
not be undone!
Step
Execution of
1 Press button
APSt func- "onPA" (selection level) displayed. Blocked if digital signal bLPS=1.
tion
2 Press button
level). Blocked if digital signal bLS=1.
3 Press button
Controller is blocked, last value of y is retained.
4 Press button
5 Press button
6 Press button
configuring switches of the controller are now in the factory setting. The
controller is in manual mode.
SIPART DR19
C73000-B7474-C140-06
Setpoint- actual value difference < 20%
Overshoot during adaptation > 10 %
Tracking mode via control signals
Safety mode via control signals
(13) once (process control level).
Procedure
(6) about 5 sec until "PS" flashes. Release button -
(8) several times until "APSt" is displayed (selection
(9) for about 3 sec until "no" appears (configuring level).
(8) once, "YES" appears (configuring level).
(9) for about 5 sec until "StrS" appears (selection level).
(13) once (process control level). It the parameters and
Configuring
Significance
81