Cae1 - Uni Input Ai1 - Siemens SIPART DR19 Kurzanleitung

Quick Reference
3.4

CAE1 - UNI Input AI1

To select measuring ranges for the UNI (universal) input AI1 and trim if necessary.
Purpose
The standard input and the input signal are selected with S4 and S5.
Requirement
•
Mode of
The selected measuring range is passed to the controller, where it is accessible
operation of
as AI1A as a standardized numerical value in the range 0 to 1. This variable can
the UNIT
be configured as required within the controller using configuring switches S15
input
to S20.
•
The measuring range of the UNI input is set using the parameters MA1, ME1,
MP1. The display range of the PV-X digital indicator is set independent of the
above using the Offline parameters dA, dE, dP.
Step
Access to
1 Press button
the CAE1
"onPA" (selection level) displayed. Blocked if digital signal bLPS=1.
function
2 Press button
level).
3 Press button
(configuring level). Controller now blocked and last value of y retained.
Set module
4 Using buttons
parameters
digital indicator.
5 Press button
switched over.
6 Using buttons
(1) indicator, or invoke a function using button
7 Press button
switched back.
8 Repeat steps 4 to 7 until all desired parameters are set.
Exit to pro-
9 Press button
cess con-
10 Press button
trol level
mode.
SIPART DR19
C73000-B7474-C140-06
Procedure
(6) about 5 sec until "PS" flashes. (Release button -
(8) several times until "CAE1" is displayed (selection
(9) about 3 sec until digital indicator SP-W (2) flashes
(7) or (8). Select parameter names in the SP-W (2)
(6) once, indicator PV-X (1) flashes, input field is
(7) or (8). Modify the parameter value in the PV-X
(6) once, indicator SP-W (2) flashes, input field is
(13) once (selection level).
(13) once (process control level). Controller is in manual
Configuring
(9).
73