Fluke Ti200 Bedienungshandbuch Seite 57

Manual Supplement
Auto Capture
The Auto Capture feature allows the user to set the Imager to capture and save
an infrared image, or series of images, automatically. Image capture can be
triggered manually or with an "apparent temperature" trigger. The temperature
trigger is set to start when a value is above or below a set limit. Regardless of
how the capture starts, the user can set the interval for when successive images
are captured and saved. The user also can set the number of images that are
captured and saved. The upper limit on number is dependent on the amount of
storage memory available.
To set and operate the Auto Capture feature:
1. Go to Camera > Auto Capture.
2. Push Start Capture to start the capture sequence.
In the Auto Capture sub-menu, you will see these options:

Start Capture

Interval

Image Count

Manual Trigger
The minimum interval available can be affected by
the file type and visible light camera settings
chosen by the user. Some combinations create
larger file sizes which take longer to capture and
save, creating a higher minimum interval
compared to others.
Executes the Auto Capture settings in camera
memory.
Set the hours, minutes, and seconds between
individual image capture events. Push / to
select the number of hours, minutes, or seconds as
an interval between images.
Select the number of images that are captured in a
sequence. Push / to manually select a
number of images. Or, push the Maximum
Memory button to select the option that will
continue capturing and saving images until the
chosen storage memory is filled.
When Manual Trigger is selected, push Start
Capture to start the automatic capture of a series of
images.
Note
2
Ti200, Ti300, Ti400 Users
3/14